Inductoheat - An Inductotherm Group Company

The choice of frequency is always a reasonable compromise in induction heating. Too low a frequency might result in undesirably large ?, which could lead to poor coil electrical efficiency. Too high a frequency could lead to long heating times that, in progressive induction heating, would require a longer heating line. Obviously, there is an [...]

FREE Webinar: Avoiding Premature Coil Failures:Design and Fabrication of Long-lasting Inductors. DR. VALERY RUDNEV, FASM | WEDNESDAY, SEPTEMBER 29 | 2 P.M. EST Gain insight into the intricacies of fabricating long-lasting inductors. Discover the causes and prevention methods of premature coil failures through: • Importance of copper grade selection • Coil stress-fatigue cracking and prevention [...]

Radyne’s Merlin system integrates heating and coating in one operation to increase throughput while facilitating coating operations for both S and J lay platforms. Merlin applies a precise two-coat FBE and copolymer coating delivering vastly improved cycle times and quality, vertical or horizontal application, and minimum manning levels. The benefits of the Merlin system have [...]

One of the most important features of modern induction heat treating equipment is the process control and monitoring capabilities as part of a modern quality assurance program. Advanced monitoring systems provide an operator with the ability to have instant and precise information about the actual heat treating cycle, and allow verification of the most important [...]

Want longer-lasting inductors? Look no further. HTPro eNews editor Ed Kubel facilitates this informative, FREE Webinar: Avoiding Premature Coil Failures:Design and Fabrication of Long-lasting Inductors. DR. VALERY RUDNEV, FASM | WEDNESDAY, SEPTEMBER 29 | 2 P.M. EST Gain insight into the intricacies of fabricating long-lasting inductors. Discover the causes and prevention methods of premature coil [...]