Inductoheat - An Inductotherm Group Company

Inductoheat & Radyne Present A Webinar On: AVOIDING PREMATURE COL FAILURES. DESIGN AND FABRICATION OF LONG LASTING INDUCTORS. Presenter – Dr. Valery Rudnev, FASM Duration 1 hour: Introduction (3 min) + Presentation (45 min) + Q&A (10 min.) + Conclusion (2 min.) Dr. Valery Rudnev’s presentation will cover the following topics related to induction heating [...]

Induction heating of the internal surfaces of a workpiece for applications such as hardening, tempering, annealing, shrink fitting, and brazing has several unique features related to the physics of the process and the selection of process parameters, compared with heating of external surfaces. There are four main coil styles for heating internal surfaces: solenoid-type cylindrical [...]

Radyne offers many fully integrated induction heating systems for the production of munitions which are utilized by both the military and commercial munitions industries. Radyne bonding and annealing systems are used to make bullets for our Law Enforcement, Military, and for the Hunting and Shooting Enthusiast. Radyne has a well established history of designing induction [...]

Gears are induction hardened by either encircling the part with a coil (so-called spin hardening) or, for larger gears, hardening them “tooth-by-tooth” or “gap-by-gap.” Article concentrates on analyzing main coil failure modes of “gap-by-gap” inductors for hardening large and medium size gears. Several case studies are discussed including degradation of laminations, copper overheating, distortion, arcing, [...]

Numerical computer modeling is one of the major factors in successful design of induction heating systems. In the fast-pace global economy, the ability of induction heating manufacturers to minimize the development time and shorten the “learning curve” through efficient computer modeling is critical for a company’s success. Click here to learn more.

Fiber is manufactured by heating a susceptor to an elevated temperature and sustaining the temperature of a large diameter bar/rod of Quartz or other similar material used to make the fibers. The heat causes a section to slowly pull down to manufacture the proper diameter fiber required. This larger starter end is connected to a [...]